Servo Machine Test stand

Servo Machine Test stand

Servo Drive  Control Unit  Minimum Specifications
•    Dynamic and Static four-quadrant operation
•    Manual and Automatic Operation Using Computer  
•    USB interface
•    Static four-quadrant operation
•    Torque control operating mode
•    Speed control operating mode
•    Flywheel operating mode
•    Lifting drive operating mode
•    Roller/calendar operating mode
•    Fan operating mode
•    Winding gear operating mode
Compressor operating mode
•    Arbitrary time-dependent load operating mode
•    Operating mode should support manual and automatic synchronization
•    Integrated galvanically isolated measuring amplifier for voltage and current measurements
•    Display of speed and torque
•    Four-quadrant monitor
•    Thermal monitoring of machine under test
•    Check for presence of shaft guard
•    Maximum speed: 4000rpm
•    Maximum torque 10Nm
Servo Drive Control Software Minimum Specifications:  
•    Recording characteristics of machines  
•    Recording of variables over time
•    determining dynamic and static operating points
•    emulates different loads
•    Measurement, calculation and display of mechanical and electrical variables
•    (Speed  torque, mechanical power output, current, voltage, active, apparent and reactive power, efficiency, power factor)
•    Simultaneous display of measured and calculated values   
•    Measurement of voltage and current (including RMS values )
•    Speed or torque-controlled operation
•    Programming of limiting values of speed or torque to prevent inappropriate loading of the machine under test.  
•    Operation in all four quadrants (display of generated torque)
•    Arbitrarily defined ramp functions for PC-controlled load experiments
•    Display of characteristics from several experiments to better illustrate the effect of parameter changes
Export of graphics and measurements to Excel file.