Computer Controlled Gear Pump Bench.
Computer Controlled Gear Pump Bench EXERCISES AND PRACTICAL POSSIBILITIES Some Practical Possibilities of the Unit: 1.-Demonstration of a gear pump in operation. 2.-Obtaining of curves H(Q), N(Q), Efficiency (Q) of the gear pump. 3.-Simultaneous representation of H(Q), N(Q) and Efficiency (Q). 4.-Adimensional study of magnitudes H*, N* and Q*. 5.-Determination of the curve H vs Q at different r.p.m. 6.-Determination of the mechanical power vs flow at different r.p.m. 7.-Determination of the efficiency curve vs the flow at different r.p.m. 8.-Determination of the map of a gear pump. Other possible practices: 9.-Sensors Calibration. Practices to be done by PLC Module (PLC-PI)+PLC Control Software: 10.-Control of the PBEC unit process through the control interface box without the computer. 11.-Visualization of all the sensors values used in the PBEC unit process. 12.-Calibration of all sensors included in the PBEC unit process. 13.-Hand on of all the actuators involved in the PBEC unit process. 14.-Realization of different experiments, in automatic way, without having in front the unit. (This experiment can be decided previously). 15.-Simulation of outside actions, in the cases do not exist hardware elements. (Example: test of complementary tanks, complementary industrial environment to the process to be studied, etc). 16.-PLC hardware general use and manipulation. 17.-PLC process application for PBEC unit. 18.-PLC structure. 19.-PLC inputs and outputs configuration. 20.-PLC configuration possibilities. 21.-PLC program languages. 22.-PLC different programming standard languages. 23.-New configuration and development of new process. 24.-Hand on an established process. 25.-To visualize and see the results and to make comparisons with the PBEC unit process. 26.-Possibility of creating new process in relation with the PBEC unit. 27.-PLC Programming Exercises. 28.-Own PLC applications in accordance with teacher and student requirements.